May 18, 2025
Labels really add to the enjoyment of visiting operators and even regular ones. I worked on drawing a schematic to place in 4 locations on the valence of the 45′ long Gerber Yard. Previously I used Publisher, so I “just” modified the files. I printed them out on glossy 13″x19″ photo paper. There were two on each sheet and then they were cut apart. Who would have guessed it would take about 9 hours.
That time included making labels for all the switch locations in Gerber and Proberta. After experimenting it was decided to use a 14-point Arial bold type. They were made on a Brother P-Touch using 1/2″ tape. Yellow labels were used to indicate crossovers, and they are identified by a yellow LED when thrown. Half the labels have been applied so far.
A laser level was used to make them level. The close-up is distorted. They really are level.
